Papercraft Hornet Deep In Design Phase
Adm_Maverick is still working on his crafty physical models, and his latest project is a precise Hornet design. He's done a variety of measurements to get the proportions right, but a few areas are tricky to correctly spec out around curvy shapes. His methods have been detailed out further at the CIC Forums for anyone who has comments or critiques. It's cool to see all the thought that's gone into things before paper's even printed!
Now, here is the part where I'm not totally sure I did this part right, so I'll walk through how I approached it and see if anyone spots any mistakes in my approach. So I need to figure out the length of the side panel of the main hull, the one highlighted in greenBut it's a 3 dimensional construct, so there is a difference between the height of the lower end of the upper end. So I couldn't just meassure it. I needed to compute it. I've been studying programming the last two semesters and one thing I've noticed I've gotten much better at doing because of that is taking a complex problem and breaking it down into smaller components. That is why I used the approach I did to address this challenge. By studying the design I saw that what I'm actually looking for is the hypotenuse of a right triangle. A triangle I only have one meassurement for. Which meant I need to get the second meassurement for the triangle so I could compute the length of the third leg.
Follow or Contact Us