Shamelessly stolen from the UseNet:
C = circle
T = triangle
S = square
X = X
other as marked
On the carrier:
C or T: cycle through hot spots. (You can also move the red arrow around with
the D-pad)
S or X: Activate hot spot
Cancel cinematic: (after youv'e seen it for the umpteenth time) Start button
Select reply: C, T, Or D-pad up/down
In flight:
Pitch and yaw: D-pad
Roll: L2 to roll left, R2 to roll right
Double turn rate: (It works, too) Hold R1 as you move D-pad
Speed up: T
Speed down: X
full throttle: L1,L2 and T
zero speed: L1,L2, and X
afterburners: L2 and R2
match speed: X and T (Doesn't seem to work right, cuts speed to zero or does
nothing at all most of the time)
autopilot: R1,R2,L1, and L2
Eject: L1,L2,R1,R2,Start, and Select
Pause and access in-flight options(skill level, invincibility,music, etc...)
Press start
Cycling through this screen works the same way as jumping through hot spots on
the carrier. C or T to select, S or X to activate. The boxes light up when
something is on, and go dark when it is off.
Cycle camera views: Select and R2. You have to go through them in order to
get back to the cockpit, sorry.
Combat:
lock target: L1 and T. To deactivate target lock, Press L1 and T again.
Switch target: L1 and X
Select next turret: Select and S. ( it is VERY hard to hit turrets. The
frame rate takes a nose dive when you get near any cap ship.
)
switch guns: L1 and C
Select full guns: L1, L2, and C
fire guns: C
Switch missile: L1 and S
Select full salvo: L1, L2, and S
fire missile: S
drop decoy: R1 and R2
activate/deactivate smart targeting: Select and X
Cloaking: L1 and R2 (Excalibur only)
Nav map:
Display map: Select and R2
Cycle through nav points: C and S
Zoom in: T
zoom out: X
Move map: D-pad
Left VDU:
Anything you do with the left VDU will happen with the SELECT button held down.
cycle through displays: Select and left or right on D-pad
Cycle through options(comms or power): Select and up or down
Select option: Select and L1
To use comms, hold select cycle left VDU to comm screen, use up/down arrows to
select receiver, then up/down again to select message, press L1 to send.
To use power distribution:
hold select, cycle to power screen, up/down to select system, R1 to increase
power,L1 to decrease. R1 and R2 set selected system to full power, L1 and L2
reset all systems to 25% power.
quick comms:
"Break and attack": select and T
taunt kittys: select and C