rapierdragon
Rear Admiral
update
Well, after several off-days (either was too tired or in too much pain) I finally managed an update.
As you can see, the second gun is now on, as well as the cockpit and the curved-gray bit that's under the cockpit-head area. If you look closely you can see the cockpit doesn't perfectly match to the lower-flat bit under it... that's more a bit of a side-effect of several test-builds than poor design/construction. Its easily enough to trim it, but considering I just spent 6 hours on the piece and its now like 4:15 a.m. I think I'll leave it for another day.
This essentially leaves the tail-fin and twin-engine area, and the bulk for the intakes on the underside. I'm hoping it doesn't take me another weak, especially since its not quite the fancy curvature that the nose/cockpit has.
Well, after several off-days (either was too tired or in too much pain) I finally managed an update.
As you can see, the second gun is now on, as well as the cockpit and the curved-gray bit that's under the cockpit-head area. If you look closely you can see the cockpit doesn't perfectly match to the lower-flat bit under it... that's more a bit of a side-effect of several test-builds than poor design/construction. Its easily enough to trim it, but considering I just spent 6 hours on the piece and its now like 4:15 a.m. I think I'll leave it for another day.
This essentially leaves the tail-fin and twin-engine area, and the bulk for the intakes on the underside. I'm hoping it doesn't take me another weak, especially since its not quite the fancy curvature that the nose/cockpit has.